Elantra Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 · (Edited)
Hi everyone,
i installed backup camera for elantra 2012 following this instruction(image) and i have some problems:
1) the monitor and the reverse light turnning on when i turn on the ignition without shifting the gear to reverse. (it supposed to turn on when i shift to reverse)
In addition the reverse light turnning on with low power without shifting to reverse.
2) the gear shift stuck doesn't move, i can't shift the gear to reverse or drive.
When i disconnect the power of the camera i can move the gear shift.

Electrical wiring Cable Gas Wire Electrical supply


Thanks
 

·
Super Moderator
Joined
·
107 Posts
I am going to guess that you have grabbed power at the light from the wrong wire. It must be connected to the positive wire of the back-up light to work correctly.

Also, and don't be offended because I don't know your level of electrical knowledge, make sure you have a good ground to the black wire. If you are not attaching it to a current ground (which is where I reccomend connecting it) you should sand away the paint before running your screw through so it will touch a good bare mental spot.
 
1 - 3 of 3 Posts
Top