Elantra Forum banner

2008 Elantra vvt issue

736 Views 1 Reply 2 Participants Last post by  Scott91370
Code P0016 so i replaced the vvt solenoid (which was a disaster getting it out but i got it eventually). I did an oil change and filter change. I checked the electrical plug that goes into the solenoid and it appears fluctuating. I wiped the code and drive it. Here i am with the code p0016 coming back on again along with p0077 now, any Ideas?
UPDATE: Problem solved. The new solenoid was defective. I replaced the solenoid again and it solved both codes. Thank you for reading.
1 - 2 of 2 Posts
P0016 should be crank/cam shaft sensor.
P0077 is Intake Valve Control Solenoid Circuit High Bank 1

Seems like you changed something you didn't need to causing another issue. I would go back and check the wiring for the VVT now that you have an error for it. Then fix the original issue.
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top